If you have a camcorder you have probably had a case where you needed to start recording but weren’t near the record button. Ragtop from the Parallax Forum built a DIY Voice Activated Video Recording Project that monitors the room noise using a small microphone. When the room sound level is high enough the system sends out an IR code using an IR (infrared LED) that simulates the record
So you probably remember that RedBull is putting on a sweet contest. The hard work is over and now you get to vote on it soon. “ THE TEAMS i3 Detroit (Detroit, MI): Winners from last year’s competition, i3 returns as a collective of hackers, makers, technologists, and automotive engineers that use fabrication equipment like metal lathes and laser cutters to create epic projects like a 16-ft tall, fire-breathing statue
If you have been listening to security now with Steve Gibson for a few years you probably heard about the portable dog killer (listen from 57:46). Not sure if Matt Meerian has listened to this Security Now episode but the Ultrasonic Dog and Cat Deterrent Project he sent in sure sounds similar to that project. Matt built this project to use on a bike to ward off dogs and
Next time you are looking for something to bling up your RC vehicle why not look around the house. bradmann85 took some CDs and attached them to his RC truck with some interesting results. I think all he needs to do next is add some of the 80mm CDs as some spinners. 🙂
This UV Exposure Box Timer project is a project that Charalampos Andrianakis built when he needed a timer for his UV Exposure Box. The project consists of a few push buttons, a few 7 segment digits and a relay. Best of all it is all controlled using a microcontroller which means that it can be custom programmed to do almost anything. Since there is a board created I can
If you are looking for a high voltage project to sink you teeth into have a look at this Full Wave Ionizer Project that petercd just built. These units can freshen and clean the air in your home. You can find them at most home stores but are usually quite expensive. “Materials required for full-wave version: 2 x 10meg ohm resistors. (limit output current for safety) 40 x diode
Check out the video above it demonstrates what a Horizontal Stabilization Camera System can do. You can see the build details over at Instructables. A camera mounted 8 feet behind the car sure gives you a cool perspective. This rig is being controlled by a huge servo and the actual arm that has the camera mounted to is has a large counterweight on it to balance it out. Not
