Xbox 360 Controller LED MOD

Precisewitem from the Hacked Gadgets Forum has put together a nice tutorial on how to perform an LED mod to your Xbox 360 Controller.

“SUPPLIES BASICS
– Soldering Iron – 15W Can be purchased as a kit from rat shack
– 30 AWG Wire Strippers – Not necessary but will help out a lot
– Resin Core Solder – Comes in kit if you get it at rat shack
– 1/16 -> 1/8 shrinkwrap and shrinkable tape – Necessary
– LEDs – All same color or specifications. Up to 3V Forward voltage
– Resistor – Calculated based upon LEDs. Lookup Resistor Calculator
– Sponge – Not necessary but helpful
– T8 Torx Skrewdriver – sold with controller case
– 30 AWG hookup wire – 28 or 30 AWG is a must as the wire has to navigate the inside of the controller case. ”