Crazy Hacks

Spin Stabilized Rocket

    This Spin Stabilized Rocket looks really cool. The three 13mm rocket motor tubes are all angled to that it spins the rocket as it flies. You can see the rocket fly in the video below. Sure is a cool idea but I am not sure the result was optimal, but I am not sure if it is more predictable than motors installed straight in though.      

How did this Nail Get in the Wood

  Before you watch the video below have a close look at the picture above and guess how this was done. There are 3 slots cut into a piece of wood, there is a real solid nail placed in the wood. Each section of wood including the outer sections are solid (just as it looks). You would not be able to remove the nail by sliding it. This was a

DIY Pop Bottle Airsoft Machine Gun

  This DIY Pop Bottle Airsoft Machine Gun should cost $10 to $15, doesn’t use any parts that can’t be found at your local hardware store and should take less then an hour to build. Best of all if you have a compressor handy you can shoot the thing to your hearts desire. You might run out of targets to shoot in a hurry though since it has a very

Titan Arm - Super Human Strength Arm

  If you would like to be a super hero for a day, this Titan Arm can make it happen! They have milled the exoskeleton system out of 6061-T6 aluminum. It hasn’t been all smooth sailing, check out this video of the mill crashing when some wrong coordinates were entered by accident. The technology and testing behind the arm is extensive. They have attempted to design it in such a

Laser Cutting 3D Objects

    When think of what a laser cutter can do you normally think of cutting things and etching surfaces. I never would have thought of making something 3D other than making notches that can link together. This video shows a technique that holds the material being worked over the main laser cutter bed using some stilts. Cuts are made in acrylic and since acrylic bends when heated the laser

Pulse Jet Go Cart

  MrBen527 has been spending some time developing a cool looking Pulse Jet Go Cart, I am a bit surprised at how receptive his neighbors are. I think his creation would be a bit more annoying than a barking dog. Watch this video to see his creation in action. MrBen527 is also creating a new version of the engine that can be seen here, this one should put on a

Mantis Hexapod Walking Machine by Matt Denton

  We have featured Matt Denton’s hexapod designs in the past. He has been spending some time working on a project that is a bit bigger than the previous ones! His new design which has been 4 years in the making called Mantis is a Hexapod Walking Machine. He has taken lots of pictures in the Facebook page (a few can be seen below). This video done by Daily Planet